Main
About polyethylene terephthalate (PET)

About polyethylene terephthalate (PET)

 

About polyethylene terephthalate (PET)

PET is polyethylene terephthalate, a thermoplastic also known as polyester or Lavsan. Depending on its internal structure, there are two different materials: polyethylene terephthalate and polyethylene terephthalate glycol. In international classification the first is designated A-PET and the second PET-G.

The internal structure of PET gives it its specific properties: high mechanical strength and impact resistance, chemical resistance, and excellent formability when cold and especially when heated.

In appearance and light transmission (90%), PET sheets are similar to clear acrylic (PMMA) and polycarbonate. However, PET has 10 times the impact strength of acrylic. PET retains its high impact resistance and strength over a service temperature range of –40 °C to +75 °C.

For long-term outdoor use, the material needs UV protection.

Without UV protection, PET can be used in the medical and food industries (its best-known use is plastic drinks bottles).

PET has high chemical resistance to acids, alkalis, salts, alcohols, paraffins and mineral oils. At the same time, PET dissolves in acetone, benzene, toluene, ethyl acetate, carbon tetrachloride, chloroform, methylene chloride and methyl ethyl ketone, so PET sheets can be solvent-bonded just as well as acrylic, polystyrene and polycarbonate.

PET can be a good substitute for clear solid polycarbonate, particularly in vandal-resistant structures, as it costs considerably less.

PET sheets have low internal stresses, which makes thermoforming simple and reliable, and finished PET products meet all the strict requirements for strength, design and appearance placed on advertising and lighting products. PET sheets do not need pre-drying. PET sheets have a lower heat capacity than polystyrene and acrylic, so heating them to forming temperature takes considerably less energy and time.

In addition, PET-G has a thermoforming range of 120–190 °C, which sharply reduces rejects during forming.

All this saves electricity and labour, and therefore lowers production costs.