Press Wall 2x2.5m, Pockets on 4 Sides, Low Legs

Structure format 2x2.5 m — a variant in the "Press wall with pockets on 4 sides, on low legs" series: the pocket for attaching to the frame is sewn not on two but on all four sides of the graphic. The graphic is still printed on one side only — pockets on four sides are about how it is attached, not about double-sided printing.

A size for your event

The series comes in sizes from 2x1.5 to 2x3 m — the size in the table above determines how much space the stand takes up: a smaller one suits a compact photo spot, a larger one a stage or a general presentation backdrop.

Pockets on four sides

The pocket edge runs around the entire perimeter of the graphic, not just the top and bottom: the frame can be fed into the graphic from any side, and the edge holds even tension all round. The image itself remains single-sided.

Low legs

The low-set frame brings the bottom edge of the graphic almost down to the floor — the structure is more stable where headroom is limited.

The structure is used as a backdrop for promotions, exhibitions and photo shoots, and as a temporary screen indoors: it is light and the frame comes apart, so it is easy to move between venues.

The structure is collapsible; the kit includes:

• plastic cable ties for tensioning the graphic
• key
• instructions

Artwork is accepted as vector or raster graphics — before printing, check the print-ready artwork requirements and the artwork approval rules.

Production time: 3-5 days from artwork approval.