Press Wall (Brand Wall) 2.5x3m, Eyelets, High Legs

Frame size 2.5x3 m is part of the "Press wall on tall legs, eyelets" series: it suits a compact photo spot by the entrance or a small stand where you don't need the full width of the hall. The graphic is printed on one side and stretched over a collapsible frame made of chrome-plated tube 25 mm on tall legs, so your logo stays at eye level even in a dense crowd.

How the graphic is attached

Eyelets are fitted all around the edge of the graphic: first the graphic is secured with cable ties at the corners of the frame, stretched horizontally and vertically with an equal gap at the sides, then gradually tightened through the remaining holes.

A size for your event

The size in the table above determines how much space the stand takes up: 2.5x3 m works for a narrow wall section or a reception area, while the wider sizes in the series suit a stage or a general presentation backdrop. The tall legs lift the bottom edge of the graphic off the floor, so people standing nearby don't block the logo.

One person can take the frame apart and put it together with no tools other than the hex key supplied, so it works both for a one-off presentation and for regular trips to exhibitions. The kit includes:

• assembly diagram
• set of hex keys
• plastic cable ties for tensioning the graphic
• carry bag — optional extra

Artwork is accepted as vector or raster graphics — before printing, check the print-ready artwork requirements and the artwork approval rules.

Production time: 3-5 days from artwork approval.