Watch Display, 50x100x50mm

The 50x100x50 mm stand is bent into a Z, and its lower tab is curled into a hook: the bracelet slips over it from above and wraps around the bend, while the watch case rests on the angled back. The bracelet stays an open ring rather than being squashed into a loop.

The hook keeps the bracelet's shape

A metal bracelet laid flat folds into an oval, and the customer can't tell whether it will fit the wrist. Fitted over the curved tab, it keeps its working diameter — you see both the size and how the links sit. The sizing question is answered before it is asked.

Angled back for the case

The watch case rests on the angled surface and doesn't hang its full weight on the hook. The load is shared between two points, so even heavy watches stand steadily and don't pull the stand forwards. The dial faces the customer.

One bend, one piece

• Bent from a single sheet, with no joints or glue.
• The bend is set by tooling and doesn't open up under load.
• It can be washed as a whole, with nowhere for dirt to collect.

Care

Wash with warm water, a mild detergent and a soft damp cloth. The hook bend is in constant contact with the metal bracelet, so wipe it without pressing. Ammonia-based glass cleaners are not for acrylic — they cause irreversible clouding. Details in caring for acrylic products.

Used in watch department display cases, on jewellery shop counters and in accessories displays. Material: clear acrylic.

Production time: 3-7 days.