Bracelet Display 170x100mm

This 170x100 mm stand is designed for bracelets: the folded top strip carries two parallel rows of semicircular cut-outs with a lengthwise groove between them. A bracelet sits in the groove as a ring, keeping its round shape instead of being squashed into a flat loop.

A bracelet should keep its round shape

Laid flat, a bracelet folds into an oval and looks smaller than it is. Customers cannot tell whether it will fit over their hand. The groove between the two rows of cut-outs holds the piece open — the diameter is clear at once, and the question of size is answered before it is asked.

Two rows of cut-outs

The cut-outs face each other and work in pairs: one holds the front of the bracelet, the other the back. The piece does not tip over or turn when the one next to it is taken off. The semicircular cut-out takes both a rigid bangle and a soft chain bracelet.

Incline and base

• The panel is inclined, so the top row is visible above the bottom one.
• The horizontal base moves the support forward.
• Bent from a single sheet, with no joints.

Care

Clean with warm water, a mild detergent and a soft damp cloth. Metal bracelets are harder than acrylic, and the edges of the cut-outs gradually pick up fine scratches, so do not rub them hard. Ammonia-based glass cleaners leave an irreversible network of micro-cracks. More in caring for acrylic products.

Used in jewellery department display cases, on bracelet counters and on market stalls. Material: acrylic.

Production time: 3-7 days.