Napkin Holder with Logo Print, 160x80x20mm

A 160x80x20 mm napkin holder: two arched walls on a flat base with a vertical slot between them. The napkins stand upright in it rather than lying in a pile, and the logo engraved on both arches can be read from either side of the table.

Engraving on both sides

A napkin holder stands in the middle of the table with guests seated around it. A logo on one side would go unseen by half of them. Here both arches are engraved, so the logo works whichever side people sit on. Engraving artwork must be vector: vector or raster graphics.

Napkins upright, not in a pile

In a flat box only the top napkin is visible, and it is hard to take without moving the rest. Standing upright, they support each other and a guest pulls one out by its edge. The stack does not spread across the table or get wet from spills, since it sits above the surface.

Body colour

The napkin holder is made from clear or coloured acrylic; the shade is chosen from the Altuglas coloured acrylic palette. A clear body does not compete with the table setting, while a solid colour makes the napkin holder stand out as part of your brand identity.

Care

• Wash with warm water, a mild detergent and a soft damp cloth.
• Ammonia-based glass cleaners cause an irreversible network of microcracks in acrylic.
• On a table that is wiped dozens of times a day, this matters.

Used on cafe and restaurant tables, coffee shop counters and in food courts.

Production time: 3-7 days.