Napkin Holder with Your Logo, 135x100mm

This 135x100 mm holder stands on a round base with two shaped panels slotted into it: the napkins go into the gap between them and stand upright. A round base has no front, so the holder looks the same from any seat at the table.

Round base, all-round view

On a shared table a rectangular stand always has its end turned towards someone. A circle removes the issue: it has no front or back, so the holder does not need turning every time the table is reset. A circle is also more stable than a rectangle of the same area, as the support spreads evenly from the centre.

Logo engraved on both sides

The logo is laser-engraved on both panels, so it is visible from opposite sides of the table. The engraving lies within the acrylic: it does not fade, collect dirt underneath or mind daily wiping, unlike a sticker, which always starts lifting at the edge. Artwork must be vector; for formats, see vector or raster graphics.

Slot-together assembly

• The panels fit into slots in the base and are held by their shape.
• No glue or fasteners, and no visible seam on the clear acrylic.
• The holder comes apart for washing and storage.

Care

Wash with warm water, a mild detergent and a soft damp cloth. Ammonia-based glass cleaners are not suitable for acrylic: the network of microcracks they cause cannot be polished out. More detail: caring for acrylic products.

Used on cafe and restaurant tables, coffee shop counters and shared meeting room tables.

Production time: 3-7 days.