"Neck" Jewellery Display for 4 Pendants 150x240mm

This 150x240 mm stand holds four pendants on comb-like teeth cut along the top edge of the silhouette on both sides. A chain goes into the slot between the teeth and stays where it was placed: neighbouring pieces do not slide towards each other or tangle.

Slots between teeth instead of an open edge

On a smooth edge a chain slides, and by the end of the day four necklaces end up in one knot that has to be untangled by hand. The slot holds the link in place, so the piece stays in its position until someone takes it off. You will notice the difference on a display that customers handle.

Teeth on both sides

The positions run along both edges of the silhouette, so the chains hang symmetrically and spread the load on the stand evenly. This also separates long and short pieces: short ones are best hung near the top, long ones on the lower teeth, where they have enough height above the base.

One-piece bent construction

• Panel, incline and base are a single piece, with no joints.
• The spacing between the parts is set by the bend and does not change.
• There are no glued joints, so no visible lines on the clear material.

Care

Clean with warm water, a mild detergent and a soft damp cloth. The edge of the teeth is in constant contact with metal, and that is where scratches build up; do not rub this area hard. Ammonia-based glass cleaners cloud acrylic irreversibly. More in caring for acrylic products.

Used in jewellery department display cases, on counters with necklaces and chains, and on market stalls. Material: acrylic.

Production time: 3-7 days.