"3 Legs" Riser h=70mm

“3 legs” riser, 70 mm high. A bracket stand with a top platform and side wings angled downwards; the platform outline is not strictly rectangular, and the edges are shaped. It is placed in groups: several stands of different heights side by side create a stepped arrangement without one large structure.

A group instead of a single riser

A one-piece stepped riser imposes a rigid spacing on the display: the steps are where they were made. A set of separate stands can be rearranged to suit the product — three levels in a row today, a pyramid or scattered islands tomorrow.

What different heights give you

• whatever is raised higher is what the customer notices first — this is how you highlight a new arrival or a featured product;
• the eye skims over an even row of identical heights without stopping;
• the two heights in the series can be combined with each other and with a flat display.

How it is made

The stand is bent from sheet acrylic and the outline is laser cut — hence the smooth edges that a saw cannot produce. When fully heated, the bend stays clear.

The edges are polished: on a clear product the edge is visible right through, and on a shaped outline a matt cut would show along its entire length.

Care

Glass cleaner is not suitable for acrylic: ammonia leaves a network of micro-cracks that polishing will not remove. Clean with warm water, a mild detergent and a soft cloth, and always while damp — see acrylic product care.

The stand works on counters, in tabletop display cases and on shelves: for cosmetics, small packs, accessories — anything that gets lost in a flat row.

Production time: 3-7 days.