2-Step Product Riser, H=220mm, L=150mm

Product riser with 2 steps, H=220 mm, L=150 mm. Two horizontal steps, solid sides and an open back; the whole structure is bent from a single sheet with no dividers on the steps. It is tall enough to work not on a counter but deep inside a display case and on a bottom shelf — where the back row would otherwise not be seen at all.

When you need a higher lift

The lower the shelf relative to the customer's eye level, the sharper the viewing angle and the more the front row hides. A low step on a bottom shelf does not help — the back row stays in the shadow of the front one. The lift of this series is designed for exactly this case.

Dimensions

• H — overall height, fixed for the series;
• L — length along the shelf, from short to wide;
• B — step depth, a separate option.

Steps without dividers

The steps are solid: they take a row of identical packs or a group of different products alike. Dividers would fix the spacing once and for all; without them, you can rearrange the display for the season without changing the equipment.

Care

Glass cleaner leaves a network of micro-cracks on acrylic that cannot be polished out. Wash with warm water, a mild detergent and a soft cloth, and wipe while damp — see acrylic product care.

The riser is designed for display cases, bottom shelves and the shop floor. It is bent from a single sheet of acrylic: when fully heated the bend stays clear, while a whitish line along it means the sheet was underheated.

Production time: 3-7 days.