Shoe Display with Logo 45x70x160mm

A shoe stand with a logo, size 70x160 mm. A long sloping surface, with a support leg dropping down at the back and a Z-shaped bend at the front leading into a low front panel. The panel does two jobs at once: it stops the pair from sliding and carries a logo facing the shopper directly.

A panel instead of a separate sign

A logo on a separate sign next to the shoes leads a life of its own: it gets moved, knocked over and eventually put away. Applied to the stand's front stop, it becomes part of the structure and always sits in line with the product.

What laser engraving gives you

Engraving removes the top layer of acrylic, so the design sits within the material rather than on it. The image does not wear off under soles or peel away with wet cleaning, which makes a real difference on a shoe stand.

Engraving requires vector artwork: line graphics are reproduced accurately, raster images are not. Details: artwork requirements and vector vs raster graphics.

How to choose the size

• the smaller size suits women's shoes and low-cut models;
• the larger one suits trainers, boots and anything needing a long support;
• the sloping surface should take the whole sole, not just the heel.

Care

Glass cleaner must not be used on acrylic: ammonia leaves an irreversible network of micro-cracks. Wash with warm water, a mild detergent and a soft cloth, and do not rub the engraved area hard: caring for acrylic products.

The stand goes in shoe shop windows and on podiums where the display is presented under the shop's own brand.

Production time: 3-7 days.