Acrylic Pen Holder for 4 pcs, 70x100x220mm

The 70x100x220 mm stand holds four pens at two points at once: the lower end goes into an oblong slot in the platform, and the body rests in a cut-out in the tall back panel. The pen stands at an angle and does not tip over even when its neighbour has been taken out, as each one has its own support.

Two supports instead of one

A stand with a single hole holds an item only at the base: touch it slightly and it leans towards its neighbour. Here the slot fixes the bottom and the comb cut-out fixes the top, so the display stays in line all day. The product is bent from a single sheet, so the distance between the platform and the back panel does not change under load.

A tall back works for display

The back panel rises above the pen body and blocks out the background: the customer sees the product against an even clear surface, not against the busy counter behind it. What this gives you on the counter:

• the sample reads against a uniform background, without visual noise;
• a pen is taken out upwards rather than pulled backwards, so its neighbours stay in place;
• the row stays in line even when some slots are empty.

Clarity depends on care

Acrylic clouds not with time but from wiping: dust under a stiff cloth acts as an abrasive. Wash with warm water, a mild detergent and a soft cloth, and do not use ammonia-based glass cleaners: they cause a network of micro-cracks that can no longer be polished out. Full explanation in the article caring for acrylic products.

Four places make this a stand for a narrow counter: souvenir pens by the till, branded samples on the reception desk, testers in a stationery department. Material: clear acrylic, laser cutting and thermoforming.

Production time: 3-7 days.