Pen, Pencil and Marker Holder for 5 pcs, 90x145x75mm

The 5-pc stand is made of two strips on an inclined back: the lower one, with round holes, takes the pen tip, and the upper one, with semicircular cut-outs, supports the body. The pen stands at an angle on two supports and does not wobble when its neighbour is taken out of the row.

Three places or five

• for 3 pcs: a compact option for a narrow counter;
• for 5 pcs: the same design with a longer row.

The only difference is the width of the body; the design and height are the same. It is worth allowing at least one spare place: customers will not dig through a tightly packed row.

12 mm hole

The lower strip is designed for a body up to 12 mm in diameter, which covers a standard ballpoint pen, a gel pen or a thin marker. A thicker item will not fit into the slot, and a thinner one will wobble and fall out of line. Check the seat diameter before ordering: it cannot be adjusted afterwards.

What damages acrylic

Not time or sunlight, but wiping. Dust trapped under a dry, stiff cloth leaves fine scratches, and the clarity is lost. Ammonia-based glass cleaners are even worse: they cause an irreversible network of micro-cracks. Wash with warm water and a mild detergent, and wipe with a soft damp cloth. Full explanation: caring for acrylic products.

Why angled rather than upright

An upright pen shows the customer only its end: the cap and nothing else. The inclined back turns the body towards the shop floor, and from standing height you can see the colour, the texture and the printed text. The same row in an upright cup would have to be sorted through by hand to see what is in it.

The stand goes on the counter of a stationery department, a stand with branded products, or a manager's desk where a pen should be in sight. Material: clear acrylic.

Production time: 3-7 days.