Plastic Pen Holder for 5 pcs, 145x85x75mm

The 145x85x75 mm stand is bent from a single sheet so that the slots run from the upright back onto the bottom in one continuous line. The pen drops into the slot from above and settles in it right down to the base — it is held along the whole length of the cut-out, not at a single point.

A slot, not a hole

A round socket is tied to one diameter: thin items rattle, thick ones do not fit. A slot takes any barrel that passes through it — round, faceted or flat. The rounded ends of the slot have no sharp edge and leave no marks on the barrels of the products on display.

Slot running into the base

The slot does not stop at the bend but continues along the base. Each item rests on a line rather than a point, and stays steady even when it is tilted as the one next to it is taken out. This cut is only possible because the stand is a single piece: on an assembled construction the line would break at the joint.

What this gives you on the counter

• One stand takes mixed products without sorting.
• Easier to clean: there are no seams for dirt to collect in.
• The row looks tidy because every item stands at the same angle.

Acrylic care

Wash with warm water and a mild detergent using a soft damp cloth. Ammonia-based glass cleaners cause an irreversible network of microcracks on acrylic. More in acrylic care.

Use it on the counter of a stationery department, at a print shop desk or on a workstation with samples. Each slot takes a body up to 12 mm. Material: clear acrylic.

Production time: 3-7 days.