Acrylic Pen Holder for 10 pcs, 160x130x120mm

The 160x130x120 mm stand is bent from a single sheet: an inclined platform with holes at the bottom and an inclined, near-vertical panel with a comb at the top. The pen tip goes into a hole and the body rests in a cut-out, so the pen stands at an angle facing the shop floor and keeps that angle until it is taken out.

One piece instead of an assembly

The product is not glued or screwed together: the sheet is laser-cut and then bent on heated tooling. The distance between the platform and the comb is set by the geometry of the bend and does not change over time: there is simply nothing to work loose. The body can be washed whole, as it has no seams for dust to collect in.

12 mm hole for the pen body

The seat is designed for a diameter up to 12 mm: a standard ballpoint pen, a gel pen or a thin marker. This is the first thing to check before ordering. A slot wider than needed lets the item tip over, a narrower one will not take it at all, and the diameter cannot be adjusted after production.

Care without losing clarity

• Warm water with a mild detergent.
• A soft cloth, damp rather than dry: a dry one charges the surface with static and attracts dust more thickly than before.
• No ammonia-based glass cleaners: they cause an irreversible network of micro-cracks.

In detail: caring for acrylic products.

Ten places is a practical size for a stationery counter, a print shop desk or a display of branded pens at reception. Clear acrylic keeps the product in view rather than the fixture under it, and does not compete with the colour of the pen itself.

Production time: 3-7 days.