"Neck" Jewellery Display for 8 Pendants 300x280mm

This 300x280 mm stand follows the outline of a neck and shoulders, and its top edge is cut in steps: eight pendants each sit at their own height and do not tangle into one knot. On this shape a necklace shows not only itself but also how it will sit when worn.

A neck shape instead of a flat panel

A necklace laid out on a counter looks like a loop, not the way it will be worn. The neck silhouette puts the piece in its wearing position: you can see where the clasp will sit, how low the centrepiece will drop and whether the necklace is too short. This removes the main objection to buying jewellery without trying it on.

Steps along the top edge

Eight pieces on one neck would inevitably overlap if they hung at the same level. The stepped cut spreads them by height: each chain starts lower than the one before, and all eight are visible at once, in tiers.

Support from the bend of the sheet itself

• The bottom is bent outwards to form the base.
• No separate stand or joints — it is a single piece.
• The width of the bent base keeps the tall silhouette stable.

Care

A large surface shows dust more than a small piece, and on clear acrylic any film is visible straight away. Clean with warm water and a mild detergent, wipe with a soft damp cloth; ammonia-based glass cleaners leave an irreversible network of micro-cracks. Full guide: caring for acrylic products.

Used in jewellery department display cases, on counters with necklaces and chains, and in large display layouts. Material: acrylic.

Production time: 3-7 days.