Phone Holder with Price Tag, 55x100mm

Phone holder with price tag, 55x100 mm. A chair-shaped design bent from a single sheet: a deep box base with a front shelf, a large inclined back rising from it, and two upright side stops. The layout is enclosed: the phone is surrounded on three sides.

Three sides instead of one

An angle stand holds the phone from below, and a knock from the side pushes it off. Here the side stops limit movement both ways, and the deep base stops the phone sliding forward. You can move a display case with this holder without rearranging the stock.

Box base

• the front shelf acts as a lip for the bottom edge;
• the box itself keeps the centre of gravity low and stops the stand sliding on the glass;
• it also takes the price tag, in the same plane as the phone.

Tall back

The back rises above the phone and leans back slightly. The phone rests on it with its whole flat face, not on one edge, so the body leaves no mark and stands at the same angle all day.

Care

Acrylic is softer than glass: ammonia-based glass cleaner leaves a network of micro-cracks, permanently. Use warm water, a little mild detergent and a lint-free cloth; do not wipe dry: caring for acrylic products.

The holder is designed for the display case and counter of a mobile phone shop, where the phone is on open display. It is bent from a single sheet of acrylic with no joints or add-on parts.

Production time: 3-7 days.