Acrylic Pen Holder for 10 pcs, 160x45x120mm

The 160x45x120 mm tray is only a few centimetres deep: it is designed for a narrow shelf where a regular stand will not fit. Ten pens lie at an angle, held at two points at once: the tip in a round hole in the front lip, the body in a cut-out in the back comb.

Held at two points

A single support lets an item turn around it and tip over. Two supports fix the pen along its axis: it stays at exactly the angle it was placed at, and the row does not spread out by the end of the day. The hole in the front lip is designed for a body up to 12 mm.

When you need a narrow profile

• A shelf by the till with only a few centimetres to the edge.
• A display case where the depth is taken up by other products.
• A wall-side stand where products are displayed in a strip.

How to clean acrylic

Warm water, a mild detergent, a soft damp cloth. Glass cleaners containing ammonia must not be used at any dilution: they cause a network of micro-cracks that clouds the surface irreversibly. Details in the article caring for acrylic products.

An angle that keeps the row in line

The pens lie at the same angle, and the row reads as a single line rather than a scattered pile. This matters more than it seems: an uneven display looks like leftovers, an even one looks like a range that has just been put out. The angle is set by the geometry of the body and does not shift when some places empty out towards the evening.

It goes on a shelf by the till, a narrow window sill in a shop window or a shelving unit in a stationery department. Clear acrylic does not visually eat into the already limited depth: you can see the shelf through it. The tray is bent from a single sheet: there are no side joints, and it can be washed whole without dismantling.

Production time: 3-7 days.