Smartphone Stand with Price Tag, 145x100mm

Smartphone Stand with Price Tag, 145x100mm. Two separate pieces in a single line: an inclined rest with a front lip on a horizontal base, and a flat upright panel standing behind it in its own bent pocket base. The panel is not attached to the stand, so you can turn it or replace it without touching the phone.

Two-piece design

When the price tag holder is fused to the stand, every information change means taking the phone off. A separate panel on its own base lifts out and goes back in independently: the phone stays put and the card is swapped in a second.

What holds the phone

• the inclined rest sets the screen viewing angle;
• the front lip takes the bottom edge;
• the horizontal base keeps the centre of gravity low, so the phone can be picked up and put back with one hand without the stand sliding.

Thickness

Choose the thickness by the weight of the phone and the height of the upright panel: a tall panel in thin sheet flexes at every touch, and it is the part touched most often when the card is straightened.

Care

Ammonia-based glass cleaner clouds acrylic with micro-cracks that polishing can no longer remove. Wash with warm water, a mild detergent and a soft cloth, and wipe while wet: caring for acrylic products.

The stand is designed for the counter and display case of a mobile phone shop or electronics department. It is bent from sheet acrylic with polished edges: on the clear panel the edge shows right through and acts as a glowing facet.

Production time: 3-7 days.