Smartphone Stand with Price Tag Holder, 95x70x60mm

Smartphone Stand with Price Tag Holder, 95x70x60mm. A narrow profile bent from one piece: the inclined back turns at the bottom into a deep front stop tray, and retaining tabs are bent out at the top sides. There are no separate ribs or projecting base: the whole structure is formed by bends in a single strip.

Deep stop tray

A shallow lip holds the phone by its very edge, and a device in a case already stands unsteadily on it. A deep tray takes the whole lower part of the body: it fits a slim smartphone as well as a model in a thick case, with room left for a price tag.

Retaining tabs

• two bent tabs at the top restrain the device at the sides;
• the phone does not slide sideways when picked up with one hand;
• the tabs do not touch the screen or cover the front.

Narrow profile

The stand takes up less width than the phone body, so no clear gaps appear between devices in a row of similar models. The display reads as a continuous front.

Because of this, the same stand works equally well in a tight row in a display case and on its own on the counter, with free space around it.

Care

Acrylic is softer than glass: ammonia-based glass cleaner leaves a network of micro-cracks, permanently. Wash with warm water, a mild detergent and a soft cloth, and wipe while wet: caring for acrylic products.

The stand is designed for the counter and display case of a mobile phone shop, electronics or accessories department. It is bent from a single strip of acrylic along heated lines, with no joints.

Production time: 3-7 days.